Dimensions:
Rake of 38 degrees.
80 Degree stretch downtube.
23-1/2" Length single downtube.
26" backbone.
Material:
1020 DOM steel tubing.
Downtube is 1-3/4" O.D. with .219" wall thickness.
Cradle tubes are is 1-3/8" O.D. with .125" wall thickness.
Backbone & seat post are 1-1/2" O.D. with .219" wall thickness.
Special features:
TIG Welded.
Accepts 11" fender.
Accepts Softail® style oil tank.
Accepts 250 rear tire with full width 1.5" belt.
Integral 5th bolt mounting within reinforced offset trans plate.

Included additionally:
Radius style fender struts for 11" fender (not shown).
Heavy duty swing arm, with 1" axle (not shown).
Front oil tank mount, polished stainless steel splash guard
with mounting hardware.
Rear frame pivot tube and hardware including pivot bearings & spacers.

NOTE 1: Requires a 1-1/4" engine-to-inner primary spacer.
NOTE 2: Gas tank mounts, coil mounts & regulator mounts
must be determined by builder.
NOTE 3: Backbone is measured from back of neck to front
of seat plate gusset. Downtube is measured from
bottom of neck to top of cradle tube joint.